Spectrometers

RLFM-124 Bend Meter Test Rig

Product Code : RLFM-124

The apparatus consists of a pipeline that contains one Bend meter. The pressure tapings from the Bend meter is taken to differential manometer to measure pressure difference. Present set-up is self-contained water re-circulating unit, provided with a sump tank and a centrifugal pump etc. Flow control valve and by-pass valve are fitted in water line to conduct the experiment on different flow rates. Flow rate of water is measured with the help of measuring tank and stop watch

EXPERIMENTATION :

➢To demonstrate the use of Bend meter as flow meter.

➢To determine co-efficient of discharge for given Bend meter.

UTILITIES REQUIRED :

➢Electricity supply: Single Phase, 220 V AC, 50 Hz, 5-15 amp combined socket with earth connection. Earth voltage should be less than 5 volts.

➢Water Supply (Initial Fill).

➢Floor Drain required.

➢Floor Area required: 1.5 m x 0.75 m

TECHNICAL DETAILS :

➢Bend meter : Material Stainless steel Compatible to 1” Dia. Pipe.

➢Water Circulation : ½ HP Pump, Crompton/Standard make

➢Flow Measurement : Using Measuring Tank, Capacity 25 Ltrs. (approx.)

➢Sump Tank : Capacity 50 Ltrs. (approx.)

➢Stop Watch : Electronic

➢Pressure measurement : By differential water manometer

➢Control Panel Comprises of : Standard make On/Off Switch, Mains Indicator, etc.

➢Tanks will be made of Stainless Steel.

➢An ENGLISH instruction manual consisting of experimental procedures, block diagram etc. will be provided along with the Apparatus